load variation

These depend on various factors related to the overall set up of the car, the fuel load variation, low gear revs and high gears revs.

取决于许多车辆的整体状况，诸如载油量的差异、高档位和低档位的转速。

When current-controlled delta modulated control scheme is applied to UPS inverter, the output voltage amplitude is unstable in case of load variation and the output voltage waveform is heavily distorted by nonlinear load. To overcome the.

当电流控制的delta调制控制策略应用于UPS逆变器控制时，存在负载变动引起逆变器输出电压幅值不稳定、负载为非线性时逆变器输出电压波形畸变严重等问题。

It is therefore important to balance out this load variation and raise the utilization of each module in order to achieve an efficient distributed processing system.

因此，必须平衡各个模块的负载，提高模块的利用率，进而提高整个系统的效率。

Reserve capacity for load variation in power market environment

市场环境下的负荷备用容量

Homotopy Based Backtracking Method for Large-scale Process Simulations with Load Variation

大规模变工况流程模拟的回溯同伦法水电水利工程模板施工规范

Large capacity and quick response controllable reactive power source is supposed to adjust voltage, maintain system reactive power flow balance, reduce network loss and improve power supply reliability due to the formation of the supergrid and intension of the load variation.

超高压大电网的形成及负荷变化加剧，增大了对大容量快速响应的可控无功功率源的要求，从而用以调整电压、维持系统无功潮流平衡、减少网损、提高供电可靠性等。

The load sensors are installed at the thickness pins of slab CCM's segment to detect the load variation caused by ferrostatic pressure floating between the strand and the rolls and to locate the end of liquid core.

采用在连铸机扇形段的调整装置位置安装测力传感器，测定由于钢水静压力变化引起的铸坯与夹持辊间作用力的大小及变化的方法，在线监测连铸过程板坯凝固末端的位置。

Comparison to the conventional thermal unit, combined cycle units are affected by more environmental conditions during the unit load variation process. The heat cost curve which only takes unit load to account can not reflect the real situation during this process.

与常规的火电机组相比，联合循环机组的变工况过程受机组运行所处的外界条件的影响较大，仅考虑机组负荷一个影响因素的机组热耗曲线不能反映真实的变工况过程。

It is the effective countermeasure against throttling loss in pumps to adopt speed regulator, so as to adjust pump speed according to load variation.

采用调速技术，使输油泵适应负荷变化，改变转速来调节输油泵的运行点，才是解决泵节流损失的措施。